CosworthSupport
1. Toolset – Installation and Connecting to Devices
Useful guide showing how to install Pi Toolset and how to use it to connect to a device and send a setup.


2. Toolset - Alarms
This guide explains how alarms are configured and set up in any device that uses Toolset software. Alarms are useful for both flagging up issues to the driver and the team during the race, but also for setting a mark in the data to show where in the race the Alarm was set off. 


3. Toolset – GPS Beacon from Google Earth
A guide to how Google Earth can be used to set a GPS beacon for the Start/Finish line of a track. This can then be used to generate beacon events. The full process from drawing the beacon line to adding it into Toolset is covered in this guide.


4. Toolset – Logging Rates
A guide to the basics of logging using an Omega device and how they can be set up using Toolset. This guide goes through the full process from setting up a logging table right through to setting the required logging rates for each channel.


5. Toolset – Offloading Data
This guide explains to the user how Toolset can be prepared for a data offload, going through setting up the path in which the outings are saved, the procedure for deleting outings after offload and the default settings that will be present if the user has not configured it manually. The guide then takes the user through the actual process of offloading the data from the logger. 


6. Toolset – Omega Device Setups and Variants
This guides gives a clear explanation of how setups, variants and tokens work in Omega devices. A useful guide for anyone who has purchased a token or who is hoping to upgrade their device level from one variant to another using a token. 


7. Toolset - Qualifying Mode Setup
This guide takes the user through the features of Qualifying Mode and how it can be set up and configured to suit the users requirements. 


8. Toolset – Sensors
This guide takes the user through the process of setting up sensor inputs in the sensors node of Toolset. This covers both digital and analogue sensors and their calibrations in the software.


9. Toolset – Adding Telemetry
This step-by-step guide takes the user through the full process of setting up a telemetry system in Toolset, from configuring the receiving laptop and the transmitting logger to watching the data live in Toolset.


10. Toolset – IPS32 Configuration
This guide explains the process of setting up the IPS32 using Toolset. A brief overview is given of each page in the IPS32 setup, explaining what that page controls and how it should be configured in order to meet the user’s requirements. Math Channels can be heavily relied upon with the IPS32 and so these are explained in detail, as well as the Buttons page and the Power Outputs section.


11. Toolset – Math Channels

This guide goes through the process of adding Math Channels and setting them up in Toolset. A useful list of all the functions and syntax is included, as well as an explanation of how a Math Channel is configured in terms of rate, quantity, units etc.


12. Toolset – System Status

A guide to explain how System Status works and how it can be configured and used.


13. Toolset – Zero Channels

This guide explains the function and the process of setting up the Zeroing features of Toolset. This is a useful feature for any sensors which require an offset to be applied (for example dampers pots).

14. Toolset – Wheelspeed Strategies
A useful advice guide on various strategies that can be used to calculate wheelspeeds depending on the application. This guide explains the strategies, outlines the pros and cons of each and explains how they can be set up to most accurately calculate the distance travelled. Switch strategies that change depending on certain conditions are also covered.

15. Toolset – CAN Stream Editor

This guide explains the process of creating custom CAN streams within Toolset. These CAN streams allow channels to be sent on a CAN bus to other devices. 


Cosworth Support
Cosworth Electronics
Quote 1 0