xiaofengwang
I just bought a GROUP N  PRODRIVE IMPREZA N2009 rally cars, CUSTOMER GUIDE display it uses a Pectel C2 ECU and Application Software:
DESCPRO
ECU Offload Tool and
Pi Toolbox
that Deskpro doesn't seem available any longer and has been replaced by pi CalTool.Is Pi CalTool compatible with a Pectel C2 ecu?

There is a port and a slot on the side of the ECU (See attachment),Where should I buy the data line? What is the slot's function?

Thank you very much.

Quote 0 0
Rob_Jarvis
Hi xiaofengwang,

If you speak with Prodrive they should be able to assist you with this one. Typically all of these boxes are locked to a Prodrive developer anyway so you will not be able to access it even if you do have the appropriate comms leads etc.

Many thanks and best regards,

Rob

Cosworth Support
Cosworth Electronics 

Quote 0 0
littleozfella
Rob,
This 8s no longer a prodruve ECU. And it's not a C2. This is one of our customers who should go through the distributor in China.
Cheers
Quote 0 0
littleozfella
Xiaofangwang.
There is a lot of issues in your car regarding wiring and possibly CANbus issues. You have a full explanation of this but if you need further clarification please contact me directly. Kimmi at Gusto will give you my details if you don't have.
Cheers
Quote 0 0
xiaofengwang
littleozfella wrote:
Xiaofangwang.
There is a lot of issues in your car regarding wiring and possibly CANbus issues. You have a full explanation of this but if you need further clarification please contact me directly. Kimmi at Gusto will give you my details if you don't have.
Cheers


Can you tell me your Email address?
Thankyou
Quote 0 0
littleozfella
Hi, I sent you a PM.  Also you have contacts to Kimi at Gusto so please ask him.

 thank you.

 Cheers
Quote 0 0