mrtuning
I'm having problems sending datasets to the ECU. Even with the Basemap by Cosworth I get the same error. Any Ideas? DatasetSendFail.jpg 
Quote 0 0
littleozfella
The file has an invalid setting so the file won't send..   In Caltool, go to  View, then check the box near to Show Validity Information.   This will show any errors in Red in the menu..  BUT there could be errors in the base file on some parameters that are not in your menu.   This can only be fixed with a Engineering dongle. If you cannot find the error email me the file.   You have my email in earlier PM....
 also on the left of the screen that you have posted is Filter Level, click on that click on Information, that will give you more details on where the issue is...  With Cosworth, you cannot assign one output twice, ie Fuel pump to two outputs.

Cheers...
Quote 0 0
mrtuning
This is the Journal I get with the error.
Quote 0 0
CosworthSupport
Hi mrtuning,

Sorry for the delay in getting back to you. I was just checking if 'littleozfella' resolved your issue - fantastic news if so, thank you. 

If you are still struggling then please let us know. 

Kind regards, 
Cosworth Support
Cosworth Electronics
Quote 0 0