VF
Hi,

I have a C16S IR Timing Beacon Receiver and I want to test it without a car being available.

In the data sheet I found the pin discirption.

[image]

Is it possible that I just supply pin 1 and 5 with 12V and then start the transmitter to test the receiver. 

Thanks in advance.

Rgds
vf
Quote 0 0
RvMorrow1
Hi VF,

Yes, this method should work. Pin 2 will pull down to 0v momentarily when the beacon is triggered.
this pulldown may be difficult to see on a voltmeter but would be visible using an scope.

Robert Morrow
Applications Engineer
Motorsport

Tel: +44 1954 253628  |  Email: robert.morrow@cosworth.com
Cosworth Electronics, Brookfield Technology Centre, Twentypence Road, Cottenham, Cambridge, CB24 8PS, England

Quote 0 0
VF
Thanks
Quote 0 0