Autoerikbs

Hi 

I have a customer who want's to use a old Pectel T6 on his Ford Cosworth engine.

The ECU is locked to another program, I don't know where the ECU comes from.

Is it posible to "reset" load a new profile in it, where it is then posiable to program with Descpro?

The engine will be running MAP based IGN and Fuel if anybody has a profile/Map for that I would like that too.

Regards ErikIMG_20180910_123306.jpg 

Quote 0 0
littleozfella
This ecu is not in Pext (open) Developer.  The ecu is probably a factory Developer (Nissan, Ford, etc). You need to have the manufacturer developer software and profiles to be able to connect to this ecu.
Quote 0 0
littleozfella
No further action required.. Customer contacted.
Quote 0 0