adrianeaton Show full post »
CosworthSupport
Hi Adrian,

What outputs / pin numbers is it that you are looking at to determine the function? Are you able to connect to the unit or is it developer locked?

Looking at our system is doesn't look like we have any records remaining anymore for that particular serial number.
Cosworth Support
Cosworth Electronics
Quote 0 0
adrianeaton
Hi,

I'm looking to work out the function of the 3 output pins pmw1 - pmw3. I can connect via Descpro and I see the output config screen as attached. I can pick one of the output types and then set the channel to be one of the options but I'm not sure which pins the output options match up to CPWM5 & CPWM6 and one says UNUSED (see pic). I have also read that some ecu's are locked at the factory and changing the options doesn't actually change what gets output, not sure if this is true or not?

Thanks,
Adrian
Quote 0 0
Claus_A_TCS
Hello

I am looking for the Profile , T2 v1-12 , Is that possible to get  ?

Is for a Ginetta ,ford zetec that have got a turbocharger mounted  ,
pectel T2  01E-500200  , 
S/N : 3295 
I/M 1/5

Best Regards
Claus Aichberger
Turbo Center I Stockholm/ Sweden
Quote 0 0
Claus_A_TCS
Hi

About my post , i did finaly get it to work and i have access to the file ( got the password ) ,
But i can not find and way to "turn" on mapsensor based fuel and ignition , This firmware seems to be TPS MAF TPS .

to run this ecu , with single throttle and turbo with stock Ford cams , do i wish to run it MAP based .
Must i change firmware ? And calibration file ?

Anyone that could help me out ?

 The ecu have  : T2V1-12 : TPS/MAF Fuel   TPS  Ign

Best Regards
Claus Aichberger



Quote 0 0
littleozfella
Hi,
    That is correct, you need firmware/profile for Turbo to be able to use MAP as Y axis. Sorry can't help you with code or profiles.

cheers..
Quote 0 0
nt499
Hello,

I just bought Caterham which has Zetec with Pectel T2.
Could you please let me know the ECU configuration.
Pectel T2  01E-500200
S/N : 2994 
I/M 1/5
I already succeeded make DescPro to communicate with ECU.

Thank you
Quote 0 0