CosworthSupport
Please find the attachment below for the latest release of Pectel ECU Offload Tool.

ECU Offload Tool 1.23.72 
https://cghl-my.sharepoint.com/:u:/g/personal/rob_jarvis_cosworth_com/EerY6loQBZZKmHzo8bydgqwBsBE21HOdi6bn1WRHC1_1iQ?e=5I4h7Q
Cosworth Support
Cosworth Electronics
Quote 0 0
Paragon
I have a problem where the Offload tool says is has SUCESS transmitted to the ECU but the reality is the logging configuration never changes, or the driver name / track / short comment. Is there some thing that needs to be setup in CalTool at the same time ?  Ver 1.23 build 72, CalTool 10.72.0.1.  
Quote 0 0
littleozfella
Most probably the setting in Caltool to block end users changing logging config is enabled..  Do you have full access to the calibration file with Caltool? 

If so, Go to Software Setup\Miscellaneous then top of the list is Disable Logging Configuration Changes..  This needs to be set to False to be able to change the logging configs.

Cheers 
Quote 0 0
Paragon
I cannot see Miscellaneous in CalTool so should I assume I do not have full access ?  If so how do I go about getting some more access ?
Quote 0 0
littleozfella
OK, what Caltool are you using, is it Pectel, or a "Developer" such as Ford Motorsport, Prodrive, or other?? What car/engine is it??  If you have a limited access metafile, then you will have to contact the supplier of your engine/calibration.
Quote 0 0