Alexis
Hi,

I work actually on an RS01 car with AliveDrive system already install on board. But we see some information missing for a correct Driving analysis.

On the video, we see the throttle and the steering angle properly but we don't see the brake information like it's not connected (always at 0)... but on my data with Toolbox, I have the brake pressure at front and at rear work properly.

Do you know why I can see it? and how I can fixe the problem?

A second information missed on video is the driver's name. I have check the file to be sure it's not a .txt but that doesn't work... Have you got the original file to be sure of my file ?

Thanks for your help,

Kind regard

Alexis Cigrand
Quote 0 0
Rob_Jarvis
Hi Alexis

The AliveDrive system needs to have the channel information sent to it in a specific format. Based on your description I suspect that this isn't set up correctly in your Toolset setup.

If you can send over your Toolset setup and also the carnum file you have been using then we can look into it further.

Drop me a private message so you can share the files.

Many thanks,

Rob

Cosworth Support
Cosworth Electronics 

Quote 0 0
Alexis
Hello Rob,

I come back to you because, the system still doesn't work (for the brake and the carnum)...

Can you help us to find why ? now we have an open Toolset set for the car so we are able to change configuration.

Thanks for your reply,

Alexis CIGRAND
Quote 0 0
Rob_Jarvis
Hi Alexis,

Send me a PM with your email address. If you send across your Toolset setup and the files you use on your USB stick as well as the AliveDrive video file showing the problems then I can look into it for you.

Many thanks and best regards,

Rob

Cosworth Support
Cosworth Electronics 

Quote 0 0
Julien
Hello,

I have the same issue, with the same car.
How you solved it for Alexis ?

Thank you in advance,
Quote 0 0