vpmotors
Good afternoon

I want to buy the MQ12 control unit from a sports team, serial number ECU 01E-500961 S / N 342 Issue: 1/5 I have a few questions regarding further operation.

can I configure the CAN bus, will all functions be available to me?

I also did not find the answer in the reference manual, does this control unit support working with the 4.2 / 4.9 lambda probe?
Quote 0 0
RobF
vpmotors wrote:
Good afternoon

I want to buy the MQ12 control unit from a sports team, serial number ECU 01E-500961 S / N 342 Issue: 1/5 I have a few questions regarding further operation.

can I configure the CAN bus, will all functions be available to me?

I also did not find the answer in the reference manual, does this control unit support working with the 4.2 / 4.9 lambda probe?


The MQ12 has both user defined encode and decode, if you however wish to recieve channels and use them in a strategy in the ECU you will need the CAN 'PEC17' upgrade.

If you can post what you are trying to do on the CAN bus we can give a more definitive answer.

You should use all Pectel ECU's with the NTK sensor as the ECU cant read the trim on the Bosch sensor. You can use a Bosch sensor if you wish, however the readings cannot be guaranteed as accurate.
Quote 0 0
vpmotors
In which what wideband lambda do you recommend ?, can you specify the exact part number?
Quote 0 0
littleozfella
Cosworth NTK lambda with AS sensor and 150mm lead. 01S-630124-A-AS enquire about other lengths.
Quote 0 0
G&G Motorsport
If Cosworth do not have NTK sensor available we can supply.  Please drop PM. 
Quote 0 0
vpmotors
write your offer in the email vpmotors@mail.ru
Quote 0 0
vpmotors
while I expect delivery of my control unit, I would like to find out a few questions regarding future use
and also in order not to "flood" several topics and not clog the forum, I will continue in this post, perhaps this information will be useful in the future

and so, I have a few questions:
regarding control of throttle drive by wire (DBW, FBW to whom as conveniently)

which inputs / outputs are best used to control the motor? (what may be suitable for this is located in connector No. 1, contact C, U, D, E and connector №4, contact J, K) 

throttle position sensor? (connector №3, input signal PIN 52, 51, connector №2 power supply +5V PIN 3,  connector №2 GND PIN 4)

sensor pedal position damper? (connector №3 input signal PIN 12, 13, connector №2 power supply PIN 3, connecor №2 GND PIN 4)

however, this is just my guess and I would like to understand it correctly or not?
Quote 0 0
littleozfella
Emailed.. 
Quote 0 0
vpmotors
Hello everyone, I finally got my control unit, cheers
however, when connecting, we encountered some problems
some errors on the top line of the screen are on, photos are attached
also we do not have the F4 key active
we are trying to figure it out but so far there is no result
as far as my engineer and I understood, we need a metafile and dataset compatible with each other or is it not ?, please clarify our doubts
61168404279__91E41B47-3487-4D46-BADA-73731298DB1F.jpg  61168405850__51ABAFFD-2EF2-4B88-89FF-34FFB626B7AF.jpg  IMG_7536.jpg  IMG_7537.jpg  IMG_7538.jpg 
Quote 0 0
littleozfella
Metafile sent
Quote 0 0