Miikii
Good Morning Mikael Lundstrom here
I have one ECU SQ6 S/N 1500, Year 2011. Software 3.37 Turbo
Have installed new gearbox into my car and like to get the advanced closed loop gearcut to work properly.
Gearbox have one sensor (0-5V)  for indication of Actual gear position.
Have this reading from potentionmeter. left side is with sensor in actual position from factory andright side is if I turn sensor 180 Deg . But inte what "lines" in DescProW should I insert the values under the transmission control
except in gear voltages and in gear positin thresholds.
Gearshift level sending signal to ecu for gear cut sensor (0-5V) , parts from the maker Kotouc gearboxes
Thanks in advance
IMG_20200118_155132.jpg  IMG_20190917_165314.jpg 
Quote 0 0
littleozfella
PM'd
Quote 0 0