winracing
Have tried about everything I can think of and can not get the rpm to stay at the rpm I have set for start line engine rpm.

It is activated thru a clutch switch. When I pull the lever in the clutch
start_line_sw_press / timer / on ....... all show ON, but the active either doesn't show active when motor is running or will flash back and forth between active and not active. The _sw never change tho, they all say on, when I have the lever pulled in.

The activeRevLimit and rev_limit_src are flashing back and forth between what I have for start line rpm and what I have for main rev limit, which I believe is happening because of the flashing between active and inactive.

That is where I am lost, I can not figure out why it wont just stay active when I pull the clutch lever in.

Some advice / help would be GREATLY appreciated.
Quote 0 0
winracing
Have also tried moving the digi switch input to base map changes and Push to Pass. The switch functions perfectly in those positions.

Function wise tho I can't see a way to change from BaseMap2 with clutch in to BaseMap1 when released. If I pull clutch in and out it will cycle thru the 2 base maps that I have set but would be great if I could have it switch on the release.

Also tried Push to Pass but that for some reason has about .300 to .500ish delay to respond. To test it I took out a lot of timing from BaseMap2 with clutch lever in so I can feel the change. When I release lever its atleast around .500sec from the time the lever is all the way out and the motor responds to the timing that's in BaseMap1.

Quote 0 0
winracing
Got the issue taken care off with the activation/not activated pulsing corrected. Appears that you can't have 0 in start line deactivation. Wanted it to turn off once it sees wheel speed and assumed having 0 inputed would do that, was wrong haha. Putting in 1 and the switch is 100% stable now between off an on, activation and deactivation.
Quote 0 0