tiamoro
hello everyone, I apologize for the language but I'm using google translator. I have a subaru impreza spec c 06 that mounts a pectel c2 ecu and I need to connect to it but I do not know how to do it. Can someone tell me what cables and what process should I do to connect with CalTool? I am attaching photos of the ecu. thanks in advance. WhatsApp Image 2018-12-28 at 17.08.15.jpeg  WhatsApp Image 2018-12-28 at 17.08.16 (1).jpeg  WhatsApp Image 2018-12-28 at 17.08.16.jpeg 
Quote 0 0
littleozfella
This is a Prodrive ECU, you can only connect to this to calibrate the ECU with Prodrive software which is not publicly available.  If you only need logging then I can help you with some software. There are 2 versions of this ecu, later versions have a Lemo connector on the back end of the ECU, in this case you need to buy a Lemo RS232 cable from Cosworth. If there is no LEMO connector on the end of the ecu, then you need to connect through the OBD port.   I can help you with this, better to PM me...

Cheers.
Quote 0 0
tiamoro
Thanks to the interest, the control unit has a 9-pin connector lemo but unfortunately those who worked before me broke the pins inside the socket and is unusable, I managed to connect via rs232 directly to the plug contacts to the pc but with caltool that with descpro tells me that metafiles are missing to read and write data ... i send you PM .. thank you!
Quote 0 0
littleozfella
Hi,
    You cannot connect to this ecu with Caltool, you need to use DescproW. There is also a high chance that this ecu will be in Prodrive code (Developer) which is not possible to change calibration. Where are you??
Cheers. 
Quote 0 0
littleozfella
Emailed you a profile..
cheers
Quote 0 0